The Basics: How Alkaline Lysis Works

Alkaline lysis was first described by Birnboim and Doly in 1979 (Nucleic Acids Res. 7, 1513-1523) and has, with a few modifications, been the preferred method for plasmid DNA extraction from bacteria ever since. The easiest way to describe how alkaline lysis works is to go through the procedure and explain each step, so here goes.
1. Cell Growth and Harvesting
The procedure starts with the growth of the bacterial cell culture harboring your plasmid. When sufficient growth has been achieved, the cells are pelleted by centrifugation to remove them from the growth medium.
2. Re-suspension
The pellet is then re-suspended in a solution (normally called solution I, or similar in the kits) containing Tris, EDTA, glucose and RNase A. Divalent cations (Mg2+, Ca2+) are essential for DNase activity and the integrity of the bacterial cell wall. EDTA chelates divalent cations in the solution preventing DNases from damaging the plasmid and also helps by destabilizing the cell wall. Glucose maintains the osmotic pressure so the cells don’t burst and RNase A is included to degrade cellular RNA when the cells are lysed.
3. Lysis
The lysis buffer (aka solution 2) contains sodium hydroxide (NaOH) and the detergent Sodium Dodecyl (lauryl) Sulfate (SDS). SDS is there to solubilize the cell membrane. NaOH helps to break down the cell wall, but more importantly it disrupts the hydrogen bonding between the DNA bases, converting the double-stranded DNA (dsDNA) in the cell, including the genomic DNA (gDNA) and your plasmid, to single stranded DNA (ssDNA). This process is called denaturation and is central part of the procedure, which is why it’s called alkaline lysis. SDS also denatures most of the proteins in the cells, which helps with the separation of the proteins from the plasmid later in the process.
It is important during this step to make sure that the re-suspension and lysis buffers are well mixed, although not too vigorously (see below). Also remember that SDS and NaOH are pretty nasty so it’s advisable to wear gloves and eye protection when performing alkaline lysis.
4. Neutralization
Addition of potassium acetate (solution 3) returns the pH to neutral. Under these conditions the hydrogen bonding between the bases of the single stranded DNA can be re-established, so the ssDNA can re-nature to dsDNA. This is the selective part. While it is easy for the the small circular plasmid DNA to re-nature it is impossible to properly anneal those huge gDNA stretches. This is why it’s important to be gentle during the lysis step because vigorous mixing or vortexing will shear the gDNA producing shorter stretches that can re-anneal and contaminate your plasmid prep.
While the double-stranded plasmid can dissolve easily in solution, the single stranded genomic DNA, the SDS and the denatured cellular proteins stick together through hydrophobic interactions to form a white precipitate. The precipitate can easily be separated from the plasmid DNA solution by centrifugation.
5. Cleaning and concentration
Now your plasmid DNA has been separated from the majority of the cell debris but is in a solution containing lots of salt, EDTA, RNase and residual cellular proteins and debris, so it’s not much use for downstream applications. The next step is to clean up the solution and concentrate the plasmid DNA.
There are several ways to do this including phenol/chloroform extraction followed by ethanol precipitation and affinity chromotography-based methods using a support that preferentially binds to the plasmid DNA under certain conditions of salt or pH, but releases it under other conditions.

Courtesy: Nick, BitesizeBio